Long time lurker, first time poster...
Well it has been a bit quiet lately and I have finally pulled the TT2 from the back of the shed to spend some time on it.
Here are some pics as it currently stands:
Attachment:
IMG_0920.jpg [ 1 MiB | Viewed 2503 times ]
Attachment:
IMG_0917.jpg [ 1.49 MiB | Viewed 2503 times ]
Attachment:
IMG_0915.jpg [ 1.47 MiB | Viewed 2503 times ]
This is a 600cc Pantah donor engine, completely stock standard down to the carbs.
Frame is a Verlicchi with an Ikomec (sp?) swingarm, front end is currently a 900ss setup.
Rear wheel is an RGV 17" and front wheel is a 900ss 17".
Tank is a TT1 fibreglass tank (tank is currently off the bike to have a tap from Carlos installed).
Planned work in the immediate future:Ikomec swing arm will upgraded to a Verlicchi tubular swingarm in the very near future, thanks Dave if you are on this forum.
(Have sourced some beautiful parts from Carlos for the rear brake calliper mount and brake stabiliser rod to allow the conversion)
Upgrade of rear shock will be part of this swap.
Planned work in the nearish future:Swap the 900ss front end for a set of 35mm magnesium Marzocchi forks in the other corner of shed.
Just trying to source a front wheel and this swap will become a reality!
Once font end is sorted plan to install a set of smaller width front fairings that is also in the back of the shed.
Planned work for down the track:Keen to put some lightweight wheels on (thinking marvic magnesium 18's) but that is going to take a little searching and a lot of saving!
Paint for fairings/tanks/wheels/frame/swingarm.
Also want to simplify and neaten the wiring at some stage as well.
I am sure I will be on here asking for advice aplenty in the coming weeks/months but I will try to post updates as they happen.