I’m 72 next month and the clip on bars are getting to my neck.
My TT2 replica has a 748 front end.
I would like to investigate the possibility of fitting a top triple clamp for sit up bars like a Monster ???
My wife has a S2R 1000 which I have measured but the holes for the top of the forks are narrower than the 748 fork tops. Could be milled to suit ?
Also I’m wondering if the triple clamp (2 forks and the axle) are at the same angle ?

Any recommendations ?

Regards
Graeme

Graeme,
Helibars maybe an option as they bring the bar up and back and are slightly wider. ( 44mm higher)
They are USA made a little pricey but… maybe someone is Australia has made something similar.
Good luck!
Paul