Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://www.ducatittandf1.com/

exhausts for TT1
http://www.ducatittandf1.com/viewtopic.php?f=10&t=238
Page 1 of 2

Author:  agshark [ Sat Jun 11, 2011 8:39 pm ]
Post subject:  exhausts for TT1

I am making the exhaust for TT1 and was seeing if i could get measurement for over all length and measurement for cones and positioning of them. I have engine 2 into 1 section and it is past that point i need the help

Thanks Jon

Author:  graeme [ Sat Jun 11, 2011 10:16 pm ]
Post subject:  Re: exhausts for TT1

Hello Jon, do you need the genuine TT1 measurements or just something that fits? Graeme

Author:  ducttf1 [ Sat Jun 11, 2011 10:25 pm ]
Post subject:  Re: exhausts for TT1

Hi Jon, what does your headpipe look like? Do you have a picture? I can try and take some pictures and measurements tomorrow. This is what I would call a TT2 style headpipe. Lou

Attachments:
SDC10229.JPG
SDC10229.JPG [ 340.84 KiB | Viewed 2557 times ]

Author:  ducttf1 [ Sat Jun 11, 2011 10:27 pm ]
Post subject:  Re: exhausts for TT1

Hi Jon, this is what I consider a TT1 headpipe. Lou

Attachments:
SDC10230.JPG
SDC10230.JPG [ 312.37 KiB | Viewed 2557 times ]

Author:  Sam [ Wed Jun 15, 2011 3:58 am ]
Post subject:  Re: exhausts for TT1

Hope you can make out the sizes on the pic, this was from a 600 pantah sure the sizes are o/s not sure if any different from the F1 !

Attachments:
P2190652mm.JPG
P2190652mm.JPG [ 826.09 KiB | Viewed 2501 times ]

Author:  ducttf1 [ Sun Jun 26, 2011 8:59 pm ]
Post subject:  Re: exhausts for TT1

Hey Guys, this is just a quick note to apologize for not listing the TT1 megaphone dimensions yet. I have been quite busy with my 'real' job during the day and putting together the TT's for Barber at night, seven days a week. I will try to get it done this week. Thanks, Lou

Author:  ducttf1 [ Sun Jul 03, 2011 3:47 pm ]
Post subject:  Re: exhausts for TT1

Hi Jon, are these photos good enough? Lou

Attachments:
SDC10277.JPG
SDC10277.JPG [ 272.57 KiB | Viewed 2372 times ]

Author:  ducttf1 [ Sun Jul 03, 2011 3:50 pm ]
Post subject:  Re: exhausts for TT1

number 2

Attachments:
SDC10279.JPG
SDC10279.JPG [ 257.96 KiB | Viewed 2372 times ]

Author:  ducttf1 [ Sun Jul 03, 2011 3:53 pm ]
Post subject:  Re: exhausts for TT1

number 3

Attachments:
SDC10280.JPG
SDC10280.JPG [ 275.47 KiB | Viewed 2370 times ]

Author:  agshark [ Mon Jul 04, 2011 3:40 am ]
Post subject:  Re: exhausts for TT1

Hi Lou
They are a big help.I have already rolled the pipe for two so i can now cut to shape.
I have made 3 battery boxes and 2 have gone too good homes for TT2s
Thanks again Jon
I am starting the cush drive for the campagnolo at the moment so i may have seen the worst of it soon

Page 1 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/