Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://www.ducatittandf1.com/

Sidestand
http://www.ducatittandf1.com/viewtopic.php?f=10&t=657
Page 1 of 1

Author:  748girl [ Wed Aug 31, 2011 2:54 am ]
Post subject:  Sidestand

Hi everyone, have just joined and warned in my introductory message, that I might have questions and that they might be stupid. First question:

My F1 came with the centre stand, no side stand. On doing a bit of reading I found that a Cagiva Allazurra side stand would do the trick. I purchased one. Now, the hard part. I want it situated on the left hand side of the bike. I realise that it will bolt on, but.... it would appear that I will need a longer engine mounting bolt than the one that is currently on the bike to accommodate this. The current bolt is 10mm with a 1.5mm thread and is looking rather lovely as it has just been cleaned, re-zinced and gold dipped, seems a shame not to use it. But what could I use instead? Or how can I achieve it. He (my husband) wants to keep the centre stand on the bike as well, I don't want it there! Suggestions gratefully accepted.

Author:  Poison [ Fri Sep 02, 2011 8:15 am ]
Post subject:  Re: Sidestand

Suggestion 1.

Try gold-dipping your husband, and then sell him...................................................!!! :D :D :D

;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;) ;)

Author:  618F1 [ Fri Sep 02, 2011 10:04 am ]
Post subject:  Re: Sidestand

I have added the Cagiva sidestand, and am using a locknut only because of the short bolt. Bolts off newer bikes are even shorter. I cannot see how both stands will fit at the same time, and that would be a lot of clutter. Either/Or? MikeV

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/