Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://www.ducatittandf1.com/

CNC yokes
http://www.ducatittandf1.com/viewtopic.php?f=12&t=2494
Page 1 of 1

Author:  kentswe [ Sat Apr 28, 2012 4:14 am ]
Post subject:  CNC yokes

Hi there.

As some of you know i have produced magnesium valvecovers for the twinns and i have recently designed yokes for the bevelbikes and pantah/f1 etc.
They have a 40mm bottom yoke and 20mm thick upper including a alu t7075 stem.
clasic design with raised radiuses around the legs.
Upper yoke is fitted with a cone to the stem for perfect geometry.
You will get a very stable frontend from this.
The offset is 25 mm and c/c is at 195mm.
Weight in at 1450grams
38mm and 40mm available,35mm can be made and they come black anodized.
Magnesium sets are not too far away.

Contact me if any interest

Attachments:
20120415215.jpg
20120415215.jpg [ 505.94 KiB | Viewed 6939 times ]
20111228137.jpg
20111228137.jpg [ 435.3 KiB | Viewed 6939 times ]

Author:  kentswe [ Wed May 09, 2012 7:30 am ]
Post subject:  Re: CNC yokes

Sorry but i cant find out how to reply to messages.

So please email me at

kent.jornevall@swipnet.se

Author:  kentswe [ Sat May 12, 2012 4:32 am ]
Post subject:  Re: CNC yokes

Hi all.

I have just confirmed with the maker that 41,7mm and 42 mm are no problem to make.
Pricing is 600€ plus shipping.
I have looked at shipping 2 kg to US and that is close to 100$
But its more economical if youget together and purchase a few sets.
I will throw in a set of magnesium valvecovers to the first 5 buyers.

Best regards
Kent

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/