Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum http://www.ducatittandf1.com/ |
|
Who knows who built this seat................? http://www.ducatittandf1.com/viewtopic.php?f=12&t=266 |
Page 1 of 2 |
Author: | Poison [ Mon Jun 27, 2011 4:22 pm ] |
Post subject: | Who knows who built this seat................? |
Attachment: WannaSeatLikeThat.jpg [ 42.47 KiB | Viewed 2669 times ] |
Author: | ducttf1 [ Mon Jun 27, 2011 5:05 pm ] | |||
Post subject: | Re: Who knows who built this seat................? | |||
Here's another two. Lou
|
Author: | sports desmo [ Tue Jun 28, 2011 5:41 am ] |
Post subject: | Re: Who knows who built this seat................? |
This was originaly made for the Harris Magnum frame but will also fit the tt frame. The larger red version on the number 3 bike has not been cut back at all and is moulded to fit the rear section of the magnum chassis. They were used quite a lot here in the UK. I think I know who has the mould so will get back later. Glyn. |
Author: | CrankyRoller [ Tue Jun 28, 2011 5:30 pm ] |
Post subject: | Re: Who knows who built this seat................? |
Three version of the Harris seat are avaible from http://www.raggededgeracing.com -Cranky- |
Author: | Poison [ Thu Jun 30, 2011 3:38 pm ] |
Post subject: | Re: Who knows who built this seat................? |
Thanks Lou and Cranky for your input! Y'know initially I was sceptical that this seat WAS indeed a Harris unit, however after cranking up the magnification on my original pic, I realised that you guys were dead right.....................!!! Obviously the builder of the bike in MY picture has modified the thing to make it more slabby, like the original TT item. Anyroadup, time to call the bodywork supplier, and get in a few cans of Polytuff......!!! |
Author: | Dick le Dog [ Fri Jul 01, 2011 1:29 pm ] | ||
Post subject: | Re: Who knows who built this seat................? | ||
Attachment: WhenTR collected the F1 from Harris in 1988 it had this one-piece thingy, which was cut up and a tank made to become this Attachment:
|
Author: | Dick le Dog [ Fri Jul 01, 2011 1:42 pm ] |
Post subject: | Re: Who knows who built this seat................? |
Attachment: I've been corresponding with Ainsley Casson of the famous DOCGB, who sent me this image. Same chassis as mine,(except the forks) and it's running on Rock Oil ..........like mine Jim's got a fairing mould, but he's in Belgium just now, so I can't ask him if he's got a mould for the seat too. |
Author: | Dick le Dog [ Fri Jul 01, 2011 1:56 pm ] |
Post subject: | Re: Who knows who built this seat................? |
Attachment: Sorry about previous image. |
Author: | Dick le Dog [ Fri Jul 01, 2011 2:16 pm ] |
Post subject: | Re: Who knows who built this seat................? |
Attachment: Attachment: Personally, I find it a bit wide after a beautifully waisted TT2 but it's stil nice to get your leg over |
Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |