Hi, it was an old picture from a bike I restored. I try and make parts and collect parts for TT's but some of my fellow Forum mates put me to shame. I also try to take pictures of 'rare' parts so I can share them on the Forum, and help anyway I can. I did make my own electical panels but they are a pain, for what looks like such a simple part. You have to cut the plate, drill and tap the holes bend and weld the tab, cut the rectangular holes for the plugs and then mill the area for the 4 pin plug! That's why all the 'replicas' of these electrical panels don't look quite right. Lot's of labor. You can see in the picture of this 'original' panel, someone cut off the end of the panel that would normally house the 4 pin plug. They also added a bunch of extra holes. Lou
| Attachments: |
|
SDC10166.JPG [ 273.08 KiB | Viewed 2313 times ] |
|
SDC10163.JPG [ 273.95 KiB | Viewed 2313 times ] |
.................but I must admit that looking at your photos of these brackets has given me a touch of inspiration for the electrics plate which I will build. I cannot give you chapter-and-verse right now, however suffice it to say that it will be a two-piece affair.............maybe a Ti-Alu contruction saving (as you can imagine) plenty of weight.......................