Hi,
Not TT/F1 parts, but I'm looking for all the parts shown in the picture, except the hose. Parts for the under slung floating rear caliper setup, as mounted on the Ducati 900SS SP, Superlights, and Monster 900S models. These would be going on the Adamo 851. These were also available from Ducati Performance as an upgrade kit. Old p/n 16181, newer p/n 968158AAA. Any help would be appreciated.
Thank you,
Bill

PM sent Bill. MikeV

hello, I do not want to sell anything, but maybe my chucks tt2 may we help you? The wheelbase of the rear caliper should be equal to that of your photos, OFF SET, I do not know.

Ciao Dall'Italia, Carlo Leoncini.

It wouldn't be too difficult to make one out of the top mount non floater.A sleeve in the axle hole to allow the bracket to float. Some rod,a few Heim joints and Viola!

Year 2000 and up OEM parts look-up.

You may already know about this, but while searching for these parts (found thanks to MikeV) and others, I came across a good website to see parts blow-ups with part numbers. Unfortunately for us it starts at the year 2000, but may be handy. Follow the instructions on the link.
Bill

http://www.ducatiomaha.com/products.asp