Like the title says, I am looking for a cush for wheel i just picked. I will make one if i need too, just hoping somebody has one stashed away!
Thanks Paul

Hi Paul, my old Marchesini's had a Ducati style bucket cush. Do you have a picture of your wheel? Lou

Here it is!
Thanks Lou!!

The bushings are different from the std. Ducati cush [thinner] and you have to shorten the drive pins but the Duc carrier will work. My 851/955 was like that.

One of Cranky's many missions is to get a supply of the Marchesini type rubber bushings made. They are now un-obtainium. If you want Ti drive pins, they are available here:
https://tpoparts.com/cat093/index.php?route=product/product&keyword=drive%20pins&category_id=0&description=1&product_id=262
They will also need to be shortened and the Ti threads going into the aluminum carrier are very grabby. Left handed as well, if I recall. Required lots of never seize and burnishing of threads.
Bill

I tried an 851 sprocket carrier no dice it is about an inch/25mm too big.
Maybe a little monster carrier?

I have a 696 carrier if that is any help?
If it will help you can have it for the cost of the post. (from Brisbane Aust)

Graeme

Hi Paul,
How do you mean "too big". My wheel is a 6" wide, going onto an '88 851. It needed a carrier off a '95 type 900ss SP with the wider wheel for proper sprocket offset (about 19mm). What is your wheel and what is it going on? I have a carrier off a '02 620 Monster with about 6mm less sprocket offset, that you can also have for shipping, if that will would help.
Bill

hopefully this will help!
Bill it is for tt2, thanks Graeme, but i think the new monster have changed to the bigger style,thanks for the offer

Paul. What is the measurement, in mm, center-to-center, from one bolt to another? I have one odd sprocket carrier here with 52mm spacing. If that fits, then it is only the five bolts and the cush rubbers/bushings you will need; what is the diameter of those holes? MikeV