Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum http://www.ducatittandf1.com/ |
|
Speedo drive http://www.ducatittandf1.com/viewtopic.php?f=24&t=12050 |
Page 1 of 1 |
Author: | richieg [ Tue Dec 01, 2020 8:36 am ] | ||
Post subject: | Re: Speedo drive | ||
Hi - Just winterising my bike so was able to get photo. Washer does belong there, as you can see. It projects about 1.5mm from speedo housing and is about 27mm OD (difficult to measure in-situ). I think it just acts as a spacer/dust shield between axle shoulder and inner race of drive gear so there would be no relative motion between it and anything else - any reasonably hard material should suffice to make one! Hope this helps - Richie.
|
Author: | tobiasg13 [ Fri Dec 04, 2020 12:03 pm ] |
Post subject: | Re: Speedo drive |
Perfect! Thanks for your help! |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |