| Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum http://www.ducatittandf1.com/ |
|
| front sprocket later F1 http://www.ducatittandf1.com/viewtopic.php?f=24&t=50 |
Page 1 of 1 |
| Author: | MarcFX [ Thu Nov 04, 2010 8:39 pm ] |
| Post subject: | front sprocket later F1 |
Simple question can anyone tell what the later 750 F1 ( Laguna Seca ) has common front sprocket to. Maybe 851. Any thoughts on the availability of sprocket for 525 chain. Thanks Marc |
|
| Author: | ducttf1 [ Thu Nov 04, 2010 9:03 pm ] |
| Post subject: | Re: front sprocket later F1 |
Hi Marc, I think the number of splines are the same but the Laguna Seca had a 520 chain with a very offset sprocket from Ducati to clear the wider tires. Hope that helps. Lou |
|
| Author: | TT1 [ Thu Nov 04, 2010 11:59 pm ] |
| Post subject: | Re: front sprocket later F1 |
Hi Marc, from the Afam catalogue the p/n is 52603 but I don't believe it is used on any other model. I was lucky enough to get one on ebay not that long ago. Maybe contact Afam and see if they can still supply? Regards, Joe |
|
| Author: | Palmer [ Fri Nov 05, 2010 8:05 am ] |
| Post subject: | Re: front sprocket later F1 |
Marc, If you do get one of the off-set sprockets for the Laguna Seca make sure it fits tight on the splines. I have seen several after market off-set sprockets that are slightly loose and cause wear on the shaft. For my race bike I used a sprocket off a newer monster or super sport and made a round aluminum plate an spacer to hold the sprocket further out on the output shaft, holding it all on with a bolt into the center shaft. I used two 5mm bolts to hold the plate to the sprocket and safety wired the three bolts together. This allowed me to get the same off-set as the stock Laguna Seca without the loose sprocket and worn output shaft. Palmer |
|
| Author: | loudbike [ Sat Nov 06, 2010 5:56 pm ] |
| Post subject: | Re: front sprocket later F1 |
Hey, Marc: if AFAM can't supply, I have those sprockets in stock - both street and race (stabilizing plate in the offset cavity) in stock. Regards, |
|
| Author: | MarcFX [ Sun Nov 07, 2010 6:25 am ] |
| Post subject: | Re: front sprocket later F1 |
Hi Steve, awesome I will send you a PM. Amusing myself today fitting SV650 wheel in standard F1 swingarm... OK don't ask, anyway offet would be useful. Best regards Marc |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|