Thank you Paul
Here we go
The the full Kokusan kit ready do ne installed,
I then proceed to remove the hold Bosch coil and try a dry possible setting with Kokusan coils and centralines.
Filippo

Does the Kokusan pick-up wiring hold up any better than the Bosch items? Or is it a carry-over issue inherent with the earlier ignitions?
Flattop

Hi Flattop
Kokusan hold up better than Bosh.
I installed it on my Pantah racer 513 cc emgine, they're good.
More reliable.
Filippo

This is the plan
Filippo

Hi all
Installed the modified ignition stuff into the frame.
This is s dry built, needed to understand how and were run the old wiring together with the new coils, wiring.
Filippo

Hi all
Keep upgrading my Pantah.
But this time is not me. I had on my spare a couple of Brembo 280 mm since years. Then I take the chance the bike is on refit. I drive to Carlo ( you will recognize carlo's workshop.)
And Carlo made the adaptor plate in ja very shirt time ( arpind a week). So again thank you Carlo for your readinness and professionalism .
Filippo

It's always a pleasure Filippo

Great stuff

Hi all
This wip take me a lot of time, because I'm very short in time to run this project.
But slowly slowly I proceed.
I rewired the kokusan to melt the Pantah plant.
Finally closed the carter and connected all toghter.
The result is a little messy but I hope it will work.

Hey Filippo....Good use of the original mounting plate. Is the TT bike getting the Kokusan ignition? This will be a good test if it is.
Flattop