Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum http://www.ducatittandf1.com/ |
|
Cranckshaft bearing http://www.ducatittandf1.com/viewtopic.php?f=25&t=11613 |
Page 3 of 3 |
Author: | 583 [ Sun Aug 13, 2017 4:56 pm ] |
Post subject: | Re: Cranckshaft bearing |
Hi Ducadini thanks for replying. This discussion is open,i was just wondering if there is an alternative to the stock crankshaft bearing, this is why i named 6307/6207, but if i understand these bearings did not comply with the stock specs. Ciao Filippo |
Author: | wdietz186 [ Wed Aug 16, 2017 9:53 pm ] |
Post subject: | Re: Cranckshaft bearing |
Filippo, Loctite make a compound specific for mounting bearings. I think it is green in color and called Stud and Bearing mount. In a pinch I've used the high strength Red 271 [I think] with decent results when the fit in the case wasn't too loose. Yes those pics do show angular contact type bearings. |
Author: | 583 [ Tue Aug 22, 2017 9:02 am ] |
Post subject: | Re: Cranckshaft bearing |
Hi Wdietz186 and thanks for Info about Loctite. Hi Cal , the bearing shown in your photo look wery close to the ones i dismounted. 75-95-12 could this code be referred to inch instead centimetres? Ciao Filippo |
Author: | Cal [ Tue Aug 22, 2017 12:55 pm ] |
Post subject: | Re: Cranckshaft bearing |
583 wrote: Hi Wdietz186 and thanks for Info about Loctite. Hi Cal , the bearing shown in your photo look wery close to the ones i dismounted. 75-95-12 could this code be referred to inch instead centimetres? Ciao Filippo Hi, The dashed #'s are for the seal. I think that must be used on a dry clutch pantah, I bet your 350 is not dry? |
Author: | 583 [ Sun Sep 24, 2017 1:53 am ] |
Post subject: | Re: Cranckshaft bearing |
Hi everybody So, after a same searches I went to my local Ducati store and ask for crankshaft bearings. For Pantah and Alazzurra engines, Ducati supply the same bearings used in 90'/00' models. There is difference between the new one and the old ones, but at the end I buy these , on the following link you find the new ones and the old ones. https://www.flickr.com/photos/156916018 ... res/6hGEvx Ciao Filippo |
Page 3 of 3 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |