Ducati TT1, Ducati TT2 and Ducati 750 F1 Forum
http://www.ducatittandf1.com/

Spacer
http://www.ducatittandf1.com/viewtopic.php?f=25&t=11830		 Page 1 of 1
Author:  flattop900 [ Thu Sep 13, 2018 3:53 pm ]
Post subject:  Spacer
Hello...
I am installing a new set of straight cut primary gears into a 600TL engine. What I need to know is the thickness of the spacer that goes onto the main shaft before the pressure plate. All of the parts manuals give the size for the one that goes on before the basket and gear, (5mm) but no reference to the one in question.
Regards....
Flattop
Author:  583 [ Fri Sep 14, 2018 11:01 am ]
Post subject:  Re: Spacer
Hi Flattop
what an interesting topic!
https://www.ducatimeccanica.com/cagiva_ ... laz_06.htm
Please for the 5mm spacer you mean the n°28 on the above link?
and which is the number of the spacer you are asking for?
ciao
Filippo
Author:  flattop900 [ Fri Sep 14, 2018 12:09 pm ]
Post subject:  Re: Spacer
Hi Filippo....
Sorry, I should have posted this picture earlier, but the manual is in pdf and won't allow page extraction. I had to photograph it off my laptop. The only parts manual I've found to show this diagram is the 350/650 Elefant. The Alazzurra manual is a little misleading. I'm installing the steel basket, later clutch. The spacer in question is #30.
Thank you for the reply....
Flattop
P.S.
How are things in beautiful Italy?

Attachments:
650 wet clutch..JPG
650 wet clutch..JPG [ 4.99 MiB | Viewed 1927 times ]
Author:  618F1 [ Fri Sep 14, 2018 3:28 pm ]
Post subject:  Re: Spacer
A bit pressed for time right now, but it is the same washer that goes with #29, found between the two bearings in the basket hub. About 2.0mm thick. As long as the bottom pressure plate clears the basket (I have seen them shoved right to the metal there, and then the plate can't spin) you will be OK. MikeV

CORRECTION. Meant it is the washer in the #31 on the schematic. About 1.5 to 2.0mm thick, with correct ID. It is in all the primary gears. MikeV
Author:  583 [ Sat Sep 15, 2018 6:57 am ]
Post subject:  Re: Spacer
Hi Flattop
I checked on a spare Alazzurra 350 clutch I have, but the shaver you need is missing on that clutch. I'm sorry.
I will find it when I will looking for other engine related stuff.
In Italy is still hot weather, good for the beach!
Ciao
Filippo
Author:  flattop900 [ Sun Sep 16, 2018 10:31 am ]
Post subject:  Re: Spacer
Thanks guys. Found one on the shelf, moving forward.
Flattop
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/