Attachment:
7E85FD4B-23BD-489D-B911-D346D139B49B.jpeg [ 1.26 MiB | Viewed 11381 times ]
Attachment:
6E512610-C46D-42A8-906C-34E4A6399A95.jpeg [ 1.39 MiB | Viewed 11381 times ]
It was spun to put the fluid holes on top, like the original. I used a sharp blade, rather than a cut-off blade, trying to keep more material; still lost about .040”, but four flat washers will fix that if needed. Most weld is inside. Will probably come back to smooth and fill the gap outside with some aluminum epoxy mix. No Way can i stitch-weld that! MikeV